Regulator Mount/Bracket

TB 9-2350-368-25

h. Regulator Mount/Bracket

Bill Of Materials

Item

Nomenclature

Part Number

NSN

Qty

1/8" Steel Plate

5 by 7-1/2 inches (12.7 by 19.1 cm)

2 by 7-1/2 inches (5.1 by 19.1 cm)

1. Cut 1/8-inch steel plate 5 inches by 7-1/2 inches (1) and 2 inches by 7-1/2 inches (2). See Figure 2-12.

2. Measure 3/4 inch from each side and end of 1/8-inch steel plate (1) and scribe a line.

3. Drill four 53/64-inch holes where scribed lines intersect.

NOTE

Face plate (1) with holes drilled can be used as template to locate

and drill 100 amp regulator mounting holes on plate (2, Figure 2-5).

4. Cut 1/8-inch steel plate (2) as shown in Figure 2-12 so that one side measures 3 inches.

5. Assemble face plate (1) and bottom plate (2) and weld assembly.

6. Weld 3-inch side of bottom steel plate (2) to powerplant test stand left rear support.

Figure 2-12. 100/200-Amp Regulator Mounting Hole Template