 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
  TB 9-2350-368-25
e. Powerplant Mount Location
Bill Of Materials
Item
Nomenclature
Part Number
NSN
Qty
3" Wide High Density Rubber Pad
1
Adhesive (or similar)
MMM-A-132
8040-01-102-2098
Kit
2
26 inches (66.0 cm)
A/R
Hardware
3
Screw
B1821BH750C150N
3
4
Washer
10910174-3
3
5
Nut
MS51922-57
3
6
Screw
B1821BH750C400N
1
7
Screw
B1821BH375C150N
2
8
Washer
10910174-8
3
9
Nut
MS51922-17
3
10
Screw
B1821BH375C550N
2
1. Measure 20 inches (50.8 cm) from front of test stand frame along left and right forward spacers. Measure
2 inches (5.1 cm) to the left of the left spacer and mark the intersection of the 20 inch mark. Align the
front edge of the engine mount with the three alignment marks and tack weld to frame. See Figure 2-9.
WARNING
Hanging loads can kill or injure you. Keep away from hanging loads
and overhead equipment. Keep hands out of area while powerplant
is being lifted or lowered on powerplant test stand.
2. Measure 51 inches (129.5 cm) from centerline of welded front engine mount. Scribe a line across frame at
this point. Align transmission mount angle apex with scribed line. Lower a M113A3 powerpack and
connect to front engine mount with two screws (3), washers (4), and nuts (5). Continue to lower
powerpack and align transmission mount with transmission. Tack weld transmission mount. Remove
two screws (3), washers (4), nuts (5) and engine from powerplant test stand. Weld transmission mount
onto test stand frame in accordance with welding specification (ANSI/AWSD1.2). See Figure 2-9.
3. Apply adhesive (1) to rubber (2) pad and to surface test stand frame in front of transmission mount.
Allow both surfaces to become tacky. Press rubber pad to test stand frame. Repeat process until a
thickness of 1 inch (2.5 cm) is established.
4. Install transfer gearcase mount on either a M113A2 or M548A1 powerpack with two screws (6 and 7),
washers (4 and 8), and nuts (5 and 9).
5. Position M113A2 or M548A1 powerpack on powerplant test stand and secure to front engine mount with
two screws (3), washers (4), and nuts (5).
6. Use gearcase mount as guide, mark holes. Remove powerpack, and drill two 1/2 inch (1.27 cm) holes
through powerplant test stand angle using transfer gearcase mount as a guide for holes. (See Figure 2-8).
2-12
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals