Figure 2-3. Frame Assembly Supports--Bottom View

TB 9-2350-368-25

NOTE

Fabrication/installation of all components that go on bottom of stand

may be fabricated/installed while stand is inverted.

5. Flip frame assembly over, locate and weld four 15-inch steel tubes (10) vertically on frame 2-1/2 inches

from each corner. Cut one end at a 45° angle.

6. Position and tack weld two 50-inch 2" by 4" tubes (11) cut on a 45° angle on both ends. One on each end

of stand on vertical tubes.

7. Hard weld if all items are in proper alignment, in accordance with welding specification QQ-A-250.

Figure 2-3. Frame Assembly Supports--Bottom View

2-4