Figure 6

MWO 9-2330-392-20-1

10. Install two new supplied ½" rear housing mounting bolts (27) and (28); and nuts,

P/N MS51922-33 (26) (figure 5) insuring that the 5.75 long bolt (27) (figure 5) is

in the middle hole with the chains (23) (figure 5) and the 5.00 long bolt (28)

(figure 5) is in the rear hole. Hand tighten only enough to hold housing in place

while front hole is drilled out.

NOTE: ONLY THE FRONT HOUSING FRONT BOLT HOLE MUST BE

ENLARGED. THE 2ND AND 3RD HOUSING MOUNTING BOLTS REMAIN

½".

11. Using the cast housing as a guide, drill out the front housing mounting bolt hole in

the drawbar and sideplates to 41/64" to accommodate the new supplied 5/8"

mounting bolt. Take care not to remove material from the cast housing hole

during drilling of the drawbar and sideplates. NOTE: the cast housing is

supplied with a front mounting bolt hole ready to accommodate the new 5/8"

supplied bolt.

12. Clean debris from drilling operation, ensuring holes are smooth and free of burrs.

13. Install 5/8" front mounting bolt (29) and nut (30). (figure 5) Torque all three nuts

to 105 lbs. ft.

14. Position emergency brake lever/cable assembly (31) and metal "U" clip (32) in

cast housing slot prior to master cylinder installation. (figure 6)

15. Install master cylinder (13) using four new master cylinder mounting bolts P/N

S630NA84CAG12354BNBA3 (33), (figure 6) torque to 30 ft/lbs +/- 3 ft/lbs.