MODIFICATION PROCEDURE.

MWO 9 -2330-390-35-1

9. SPECIAL TOOLS; TOOL KITS; JIGS; TEST, MEASUREMENT, AND

DIAGNOSTIC EQUIPMENT (TMDE); AND FIXTURES REQUIRED.

a. Hand tools and tool kits necessary to apply MWO are listed:

NOMENCLATURE

NSN

CAGEC

SUPPLY CATALOG

Tool Kit, General Mechanic's

5180-00-177-7033

50980

SC 5180-90-N26

Kit, Redundant Power

1730-01-4062585

21439

8D00220-1

Wrench, Twist Lock

21439

8D00136 (Provided w/ Dolly)

Drill Set, Twist

5133-00-293-0983

55719

SC 4910-95-CL-A74

Drill, Electric, Portable

5130-00-293-1849

81348

SC 4910-95-CL-A74

Welder, Short Arc Mig

3431-01-071-9104

30367

P/N SWM-14

b. Tools necessary to apply MWO are contained in the following shop set:

NOMENCLATURE

NSN

CAGEC

SUPPLY CATALOG

Shop Equipment,

4910-00-754-0654

19204

SC 4910-95-A74

Automo tive Maintenance

And Repair

10. MODIFICATION PROCEDURE.

WARNING

Use extreme caution when handling heavy parts. Lifting device is required

when parts weigh over 50 lb (23 kg) for a single person lift, over 100 lb (45

Kg) for a two person lift, and over 150 lbs (68 kg) for a three or more person

lift. Keep clear of heavy parts supported only by lifting device. Failure to

follow this warning may cause serious injury or death to personnel

NOTE

Hydraulic lines should be tagged before removal.

Positioning cylinder ports should be plugged with masking tape or other

suitable means as lines are disconnected or fittings are removed.

A suitable container should be used to catch any draining hydraulic fluid.

Ensure tha t all spills are properly cleaned.

a. DOLLY PREPARATION

NOTE

Preparation procedures are the same for front and rear dollies.

1. Uncouple Dolly set from Tow vehicle

2. From the transport or travel mode (Figure 2) perform operations needed to

detach front and rear dollies (Refer to Appendix A).