INSTALLATION

MWO 9-2330-390-25-1

APPENDIX C:

TOP AND BOTTOM BEAM AND HYDRAULIC LIFT

CYLINDER REMOVAL / INSTALLATION (Con't).

b. INSTALLATION

1. Position bottom beam to align suspension mount tabs with suspension frame (9).

2. Using tapered chase pins supplied with kit, attach bottom beam to suspension frame (9).

Insure that washers (10) previously removed are reinstalled to consume gaps that may

exist.

3. Drive each tapered chase pin out of connection made in task 2 with clevis pin (12). Use

proper care to avoid inference with suspension member (9) and washers (10).

4. After each clevis pin (12) is installed, insert new cotter pin (9) to complete connection.

5. Attach cylinder shims (25) to tube mounts on bottom beam (19 Rear, 20-Front) using

flat head screws (26). Torque each screw to 10 ft-lbs.

6. Position mounting tabs on lower vertical tube (33) between the tube mount tabs on the

bottom beam.

C-5