WARNING (cont)

TM 32-5985-343-14&P

CAUTION

When installing scaffold winch assembly, make sure that crank axis is parallel to tower face A.

The winch will then be able to move the antenna carriage when it rides on the horizontal tracks

on the tower adapter. (Page 2-20)

CAUTION

Before tower is completely erect, check alignment of studs in tower support with mating holes in

tower leg that comes down. If holes and studs do not align, correct the alignment. Otherwise

damage to tower leg or tower support will result. (Page 2-23)

WARNING

Never use elevator erection sling to raise structural member when sling is supporting member by

frictional contact only. Sling must go through hole or be safely secured over welded track tabs

when lifting track or brace. Elevator hoist operator must stand inside tower while operating

hoist, to avoid being under members being raised. (Page 2-29)

CAUTION

Before beginning to raise or lower loads, always operate controls momentarily to eliminate all

slack in cable. Otherwise starting can cause shock load, which can cause damage to hoist or

rigging. (Page 2-29)

WARNING

Persons must never try to ride elevator. It does not have safety features required for carrying

persons. (Page 2-32)

CAUTION

Before raising or lowering load with elevator hoist, always operate controls momentarily to

eliminate all slack in cable. This way shock load and resulting damages to hoist or rigging are

avoided. (Page 2-32)

WARNING

Do not let elevator assembly go beyond its upper limit of travel. Take extreme care when it

approaches this position. Otherwise excessive cable stress could result, and this stress could

cause equipment failure or injury to persons. (Pages 2-32, 5-13)

vii