ELEVATOR HOIST.

TM 32-5895-342-14&P

(5) Connect primary power source. Be sure

b. Circuit Breaker Removal. Refer to figure E-9.

tags match with terminal connections.

(1) Remove fastener screws that secure

junction box cover. Remove junction box cover.

5-14 ELEVATOR HOIST.

(2) Remove two nuts(8), lockwashers (7), and

screws (6) that secure circuit breaker clamp (5).

Remove circuit breaker clamp.

a. Removal. Refer to figure 2-10.

(3) Remove four nuts (8), lockwashers (7),

(1) Detach free end of hoist cable (12) from

and screws (10) that secure 20-ampere breaker (9) and

top tower step. Using hoist control reel in cable, thread

three 15-ampere circuit breakers (14). Pull circuit

it through sheave (10) on tower top brace.

breakers from holders.

(2) On power junction box, set HOIST circuit

breaker to OFF position. Disconnect hoist control from

c. Circuit Breaker Replacement. Refer to figure E-

hoist assembly.

(3) Remove four bolts (4), bevel washers (5),

(1) Insert each circuit breaker into its

hex nuts (6) and locknuts (7). Remove hoist assembly

respective holder.

Secure with four screws (10),

(8) from hoist mount (1).

lockwashers (7), and nuts (8).

(4) Remove four hex nuts (2) and locknuts (3)

(2) Install circuit breaker clamp (5). Secure

from anchor bolts in hoist pier. Remove hoist mount (1).

with two screws (6), lockwashers (7), and nuts (8).

(3) Attach junction box cover. Secure with

b. Installation. Refer to figure 2-10.

fastener screws.

(1) Install hoist mount onto four anchor bolts

in hoist pier. Secure with four hex nuts (2) and locknuts

d. Junction Box Replacement. Refer to figure 2-

(3).

14.

(2) Install hoist (8) to hoist mount (1). Secure

(1) Remove hex nut and tower step. Install

with four bolts (4), washers (5), hex nuts (6) and

junction box mount plate (5). Replace tower step and

locknuts (7).

hex nut.

(3) Connect hoist control to hoist assembly.

(2) Install junction box assembly (7) on

On power junction box set HOIST circuit breaker to ON

junction box mount plate (6). Secure with four bolts (3);

position.

lockwashers (4), and hex nuts (5).

(4) Using hoist control, reel out hoist cable

(3) Install convenience outlet (2) to junction

(12). Thread cable through sheave on tower top brace.

box mount plate (6). Secure with bolt (3), lockwasher

Secure free end to top tower step.

(4), and hex nut (5).

(4) Connect all power leads to junction box

and convenience outlet. Be sure tags match with

terminal connections.

5-16