Click here to make tpub.com your Home Page

Page Title: VEHICULAR INSTALLATION
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

Back
Section II. INSTALLATION
Up
TM-11-5985-379-14-P Antenna AS-2259/GR (NSN 5985-00-106-6130) Manual
Next
Figure 2-1. AS-2259/GR Installation.

TM 11-5985-379-14&P
NOTE
B e f o r e connecting mast sections, wipe unpainted surfaces
clean of mud or dirt to ensure good electrical contact.
d.  A s s e m b l e mast by raising top mast assembly and inserting mast sections
a s shown in Figure 2-lC.
e .  A d j u s t tension on all elements until mast is plumb.  E l e m e n t s need not be
e x c e s s i v e l y t a u t .  A tension of approximately 3 to 5 pounds is sufficient.
2.2.1
VEHICULAR INSTALLATION
I n s t a l l a t i o n of the AS-2259/CR antenna on vehicular mounts is the same as
t h a t of the antenna as described in 2.2 above, except the vehicular whip
m o u n t is used rather than the AN/PRC-47 radio, and the Adapter MX-9313/GR
i s used instead of the base assembly,  U s e only as many mast sections as
a r e necessary to raise the top of the antenna to approximately 16 feet 9
i n c h e s high.  S e e Figure 2-5.
2.3
DISASSEMBLY PROCEDURE
D i s a s s e m b l y is performed in the reverse order of assembly.  R e m o v e stakes,
d i s a s s e m b l e mast, and coil elements on hooks provided on top mast section.
When coiling the radiating elements, first pull all four anchor stakes and
l e a v e them on the ground.  R e t u r n to the mast and coil each element onto
t h e hooks, pulling the element toward the mast as it is coiled.  O t h e r w i s e
k i n k s in the elements may result and the elements may become entangled.
S e c u r e the elements in place on the top mast assembly with the web belt.
2.4
REPACKING PROCEDURE
I n s e r t top mast assembly, with elements coiled on it, in the large pocket in
t h e c a r r y i n g c a s e .  I n s e r t the remaining mast sections in the pockets provided.
T h e antenna packs more compactly if the base assembly is inserted in a mast
s e c t i o n which is inserted into the third pocket (one pocket away from the top
m a s t assembly).  B e sure the tune-load chart is attached to the base assembly.
F o l d over the side flaps, roll the pack tightly, and buckle the two small
belts.
2-2

Privacy Statement - Press Release - Copyright Information. - Contact Us