Replacement.

TM 11-5985-371-12&P

b. Replacement.

(1) Cut two 220-foot pieces of antenna wire from the 500-foot roll.

(2) Wrap one antenna wire at the midpoint (110 feet from each end) around

antenna connector

on the terminating resistor box

(terminal A will hold

the antenna wire going to antenna stakes B and C) (para 2-5e)). Place and tighten

a conductor splice

at the midpoint.

(3) Measure 60 feet from the midpoint of each loose end of the antenna wire,

make a loop, and place a conductor splice at each point. These loops will connect to

the snap hooks on the lanyards attached to antenna stakes B and C ((6) below).

(4) Repeat the procedures ((2) and (3) above) for the antenna wire to be con-

nected to terminating resistor box connector

(terminal B will hold the antenna

wire going to antenna stakes A and D (para 2-5e)).