Table 4-2. Organizational Troubleshooting

TM 11-5985-371-12&P

Organizational Troubleshooting - Continued

Table 4-2.

Malfunction

Test or Inspection

Corrective Action

NOTE

Do not perform step 7 if the reading in step 5 was normal.

Untie the halyard

from the cleat

on the balun

and lower the

Step 7.

terminating resistor box

to the base of the mast. (Make sure the

antenna wire loose ends are disconnected from the connectors on top of

the balun and the two separate antenna wires are not making contact.)

Measure the resistance between the two antenna connectors on the ter-

minating resistor box

. Reading should be 600 ohms.

If normal, raise the terminating resistor box with the halyard

, and tie the loose end of the halyard to the balun cleat

. Reconnect the antenna wire loose ends to the balun.

If abnormal, repair and replace the terminating resistor box

Repeat steps 1 through 7 above.

FAULTY TRANSMISSION.