Removal of Terminating Resistor Stop.

TM 11-5985-371-12&P

(3) Disconnect the pulley snaphook

from the top guy plate

. Coil and

bind the halyard

h. Removal of Terminating Resistor Stop.

and separate the

Remove the four wingnuts

and terminating

terminating resistor stop

from the mast

resistor stop clamp

on the ter-

Replace the four wingnuts

minating resistor stop

i. Disassembly of Mast.

(1) Remove the insulator from the mast base. (See illustration on page 2-8).

(2) Separate the 16 mast sections and the three guy plates.

(3) Pull the mast base from the ground. Remove the support plate.

j. Packing Carrying Frame and Carrying Case. See section VI, chapter 4.

OPERATION UNDER UNUSUAL CONDITIONS

Section III.

2-7. Sandy or Marshy Terrain.

If the ground in which the

mast base, guy stakes, and

antenna rods are to be

inserted is sandy or marshy,

get specific instructions

from your supervisor on how

to reinforce the mast base

and stakes. The guy stakes

may be reinforced by driving

the four guy stakes into the

ground at least 2 inches

below the surface and burying

the three guys connected to

each guy stake in the ground.