LOCATING ANCHOR POSITIONS AND TOWER BASE

TM 11-5985-362-13

Move to anchor location 6A and install second 66 inch anchor using the method described above, until

anchor eye is a maximum of two inches above ground level.

Return shovel/pick to transit case.

c. LOCATING ANCHOR POSITIONS AND TOWER BASE

Locating the positions for the single front anchor (ANCHOR 1), two anchors (ANCHOR (6) and 7) on each side

and tower base is done by using the CENTER, BACK and SIDE LAYOUT WIRES contained on REEL NO. 4.

Unreeling of the center and back layout wires is done by using a RL-31-(*) reeling machine with removable axle

RL-27-(*). Positioning of the side layout wire requires the axle to be removed from the reeling machine and hand

carried by two crewmembers with the wire unreeled as you walk from point to point.

NOTE

The RL-31-(*) reeling machine and RL-27-(*) axle must be procured from normal supply channels.

(1) ANCHOR 1 AND TOWER BASE.

Use CENTER LAYOUT WIRE to locate ANCHOR 1 and TOWER BASE as follows:

2-14