Section VI. TESTING

TM 11-5985-334-34

practical touchup.

counterbores, slots, grooves, shoulders, flanges,

c. Repair. It is uneconomical to repair mechanical

teeth, tapped holes, and threaded members for

metal parts. Replace as necessary.

roughness of surface or corrosion.

(3) Inspect plated areas for damage requiring

2-34. Molded Plastic Parts

replating or refinishing beyond touchup repair.

Plastic parts include insulating members, mounting

c. Repair.

Machined metal parts are

pads, etc. Proceed as follows:

uneconomical to repair. Replace as necessary.

a. Cleaning.

2-33. Mechanical Metal Parts

(1) Use an air jet to blow dirt from surfaces,

holes, and crevices.

a. Cleaning. Mechanical metal parts include

(2) Wipe clean with a solvent-moistened lintless

mounting plates, mounting clamps and brackets,

cloth.

nuts, bolts, screws, washers, handles, fasteners, and

hardware. Clean in cleaning machine, or as set forth

(3) Dry and polish with a clean lintless cloth.

b. Inspection. Inspect for signs of corrosion,

in paragraph 2-29.

cracks or wear.

b. Inspection. Inspect for physical damage or

c. Repair. It is uneconomical to repair molded

deformation. Check for corrosion and damage which

plastic parts. Replace as necessary.

would require replating or refinishing beyond

Section VI. TESTING

2-35. General

for components comprising an operable system.

(2) AB-621A/G-Refer to TM 11-5985-334-10

This section contains tests for use by direct support

for components comprising an operable system.

organizations. These procedures set forth specific

(3) MK-2044/GRefer to TM 11-5895-334-10

requirements that repaired equipment must meet

for components comprising the 100 foot extension

before being returned to the using organization. The

kit.

testing procedure may also be used as a guide for

b. Test Connections and Conditions. Refer to TM

the testing of equipment that has been repaired at

11-5895-334-10 for set up of equipment for

direct support.

operational tests.

2-36. Operational Test

c. AB-621/G Tests.

Control settings

a. Test Equipment and Material.

(1) AB-621/GRefer to TM 11-5985-334-10

2-28