SECTION I. INTRODUCTION

TM 11-5821-2W34P

SECTION I

INTRODUCTION

entered in the first and second positions of the Uniform

Scope

SMR Code format as follows:

This manual lists spares and

parts; special tools;

Code

Definition

special test, measurement, and diagnostic equipment

Item procured and stocked for anticipated or

(TMDE), and other special support equipment required

known usage.

for performance of direct support and general support

Support item, excluding support equipment,

maintenance of the AS-2285/ARC and AS-2285AIARC.

procured for initial issue or outfitting and stocked

It authorizes the requisitioning and issue of spares and

only for subsequent or additional initial issues or

repair parts as indicated by the source and maintenance

outfittings. Not subject to automatic

codes.

replenishment.

Item is not procured or stocked because the

General

requirements for the item will result in the

This Repair Parts and Special Tools List is divided into

replacement of the next higher assembly.

the following sections:

A support item that is not stocked. When

Section II. Repair Parts List. A list of

required, item will be procured through normal

spares and repair parts authorized for use in the

supply channels.

performance of maintenance. The list also includes

parts which must be removed for replacement of the

NOTE

authorized parts. Parts lists are composed of functional

Cannibalization or salvage may be used

groups in numeric sequence, with the parts in each

as a source of supply for any items

group listed in figure and item number sequence.

source coded above except those coded

b. Section III. Special Tools List Not

XA and aircraft support items as

applicable.

restricted by AR 700-42.

c. Section IV. National Stock Number and

(2) Maintenance code. Maintenance codes are

Part Number Index. A list, in National item identification

assigned to indicate the levels of maintenance

number (NIIN) sequence, of all National stock numbers

authorized to USE and REPAIR support items. The

(NSN) appearing in the listings, followed by a list, in

maintenance codes are entered in the third and fourth

alphameric sequence, of all part numbers appearing in

positions of the Uniform SMR Code format as follows:

the listings. National stock numbers and part numbers

(a) The maintenance code entered in the third

are cross-referenced to each illustration figure and item

position will indicate the lowest maintenance level

number appearance.

authorized to remove, replace, and use the support item.

Explanation of Columns

The maintenance code entered in the third position will

a. Illustration This column is divided as

indicate one of the following levels of maintenance:

follows:

Code

Application/Explanation

(1) Figure number. Indicates the figure number

F-

Support item is removed, replaced, used at the

of the illustration on which the item is shown.

direct support level.

(2) Item number. The number used to identify

H-

Support item is removed, replaced, used at the

item called out in the illustration.

general support level.

b. Source, Maintenance, and Recoverability

(b) The maintenance code entered in the fourth

(SMR) Codes.

position indicates whether the item is to be repaired and

(1) Source code. Source codes indicate the

identifies the lowest maintenance level with the capability

manner of acquiring support items for maintenance,

to perform complete repair (i.e.,

repair, or overhaul of end items. Source codes are