 |
|||
|
|
|||
|
Page Title:
Figure 4-1. Gear train assembly A3, exploded view. |
|
||
| ||||||||||
|
|
  nuts A2H4 that secure discriminator board A2 to coupler
NOTE
assembly.
If the old shaft MP10 is used, larger
g. Replacement of Servo Amplifier Card A1.
spring pin Is required to assure the gear
(1) Resolder all wires. Insure that wires
Is securely positioned on the shaft.
are connected to proper terminals.
(3) Refer to paragraph 4-8d.
for
(2) Attach servo amplifier card to Al to
replacement of A3C1.
backing plate MP21 by replacing five screws A1H1. Nut
f.
Replacement of Phase Discriminator Board
and washer MP6H1 and loop clamp MP6 are attached to
A2.
screw A1H1.
(1) Resolder all wires. Insure that wires
(3) Replace cover MP11 by tightening four
are connected to proper terminals.
screws MPllH4 and two screws MP11H2.
(2) Replace four screws, lockwashers, and
Figure 4-1. Gear train assembly A3, exploded view.
4-9
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals