|
| |
Back
PILOT DIRECTIONAL CONTROL POSITION LINEAR VARIABLE DIFFERENTIAL TRANSDUCER (LVDT) INSTALLATION | Up
TM-1-1520-238-23-7-2 Helicopter Attack AH-64A Apache (NSN 1520-01-106-9519) (EIC: RHA) Manual | Next
PILOT DIRECTIONAL CONTROL POSITION LINEAR VARIABLE DIFFERENTIAL TRANSDUCER (LVDT) INSTALLATION – continued |
TM 1-1520-238-23
11-914
11.211.
PILOT DIRECTIONAL CONTROL POSITION LINEAR VARIABLE DIFFERENTIAL TRANSDUCER
(LVDT) INSTALLATION – continued
a. Install clamp (1) on LVDT (2).
(1) Position clamp (1) on LVDT (2).
(2) Install bolt (3) through washer (4), one ear of
clamp (1), electrical lead (5), washer (6), and
other ear of clamp (1).
(3) Install washer (4) and nut (7).
b. Install connector (8) on LVDT wire harness (9),
if required.
(1) Cut wire harness (9) length to 19.0 INCHES.
(2) Use Table 1 to install connector (8) on wire
harness (9) (TM 55-1500-323-24).
c. Install LVDT (2) on rod end (10).
(1) Install nut (11) and keywasher (12) on rod end
(10).
(2) Install LVDT (2) on rod end (10).
(3) Measure 1.0 INCH between center of rod end
(10) and keywasher (12).
(4) Tighten nut (11).
(5) Lockwire keywasher (12) to nut (11). Use wire
(item 222, App F).
GO TO NEXT PAGE
M04-1860-6
2
1
3
7
4
6
5
4
M04-1860-7
TABLE 1
LVDT WIRE HARNESS
WHITE
BLUE
GREEN
ORANGE
CONNECTOR
PIN 1
PIN 2
PIN 3
PIN 4
M04-1860-2
2
12
11
10
VIEW
LOOKING UP AND AFT
1.0 IN.
9
8
|
