|
| |
Back
PILOT COLLECTIVE STICK POSITION LINEAR VARIABLE DIFFERENTIAL TRANSDUCER (LVDT) AND VARIABLE RESISTOR ROD END REPLACEMENT | Up
TM-1-1520-238-23-7-2 Helicopter Attack AH-64A Apache (NSN 1520-01-106-9519) (EIC: RHA) Manual | Next
PILOT COLLECTIVE STICK POSITION LINEAR VARIABLE DIFFERENTIAL TRANSDUCER (LVDT) AND VARIABLE RESISTOR ROD END REPLACEMENT – continued |
TM 1-1520-238-23
11-908
11.209. PILOT COLLECTIVE STICK POSITION LINEAR VARIABLE DIFFERENTIAL TRANSDUCER (LVDT)
AND VARIABLE RESISTOR ROD END REPLACEMENT – continued
11.209.5. Inspection
a. Check removed and attaching parts for dam-
age (para 11.190).
b. Check removed and attaching parts for corro-
sion (para 1.49).
c. Check all installed bushing(s) and/or bear-
ing(s) for wear (para 11.190).
d. Check all removed bushing(s) and/or bear-
ing(s) for wear (para 11.4).
11.209.6. Installation
a. Install jam nuts (11) and (12) on rod ends (1)
and (2).
b. Install LVDT rod end bearing (1) and variable
resistor rod end bearing (2) on bracket (3).
(1) Aline rod ends (1) and (2) with bracket (3).
(2) Install bolt (7) through washers (8) (as re-
quired), bushing (9), bracket (3), rod end (1),
spacer (10), washers (8) (as required), and
rod end (2).
(3) Check fit of self-retaining bolt (7) (para 11.1).
(4) Install nut (5) and washer (6) on bolt (7).
NOTE
Torque procedures will be performed dur-
ing pilot collective control position linear
variable differential transducer (LDVT)
installation.
GO TO NEXT PAGE
M04-5085-2
1
2
7
11
12
10
6
4
5
8
3
9
8
|
