|
| |
Back
CPG LONGITUDINAL CONTROL POSITION LINEAR VARIABLE DIFFERENTIAL TRANSDUCER (LVDT) INSTALLATION | Up
TM-1-1520-238-23-7-2 Helicopter Attack AH-64A Apache (NSN 1520-01-106-9519) (EIC: RHA) Manual | Next
CPG LONGITUDINAL CONTROL POSITION LINEAR VARIABLE DIFFERENTIAL TRANSDUCER (LVDT) INSTALLATION – continued |
TM 1-1520-238-23
11-879
11.201.
CPG LONGITUDINAL CONTROL POSITION LINEAR VARIABLE DIFFERENTIAL TRANSDUCER
(LVDT) INSTALLATION – continued
11.201.3. Installation
a. Install clamp (1) on LVDT (2).
(1) Position clamp (1) on LVDT (2).
(2) Install bolt (3) through washer (4), one ear of
clamp (1), electrical lead (5), washer (6), and
other ear of clamp (1).
(3) Install washer (4) and nut (7).
b. Install connector (8) on LVDT wire harness (9),
if required.
(1) Cut wire harness (9) length to 28.0 INCHES.
(2) Use Table 1 to install connector (8) on wire
harness (9) (TM 55-1500-323-24).
c. Install LVDT (2) on rod end (10).
(1) Install nut (11) and keywasher (12) on rod end
(10).
(2) Install LVDT (2) on rod end (10).
(3) Measure 1.0 INCH between center of rod end
(10) and keywasher (12).
(4) Tighten nut (11).
(5) Lockwire keywasher (12) to nut (11). Use wire
(item 222, App F).
GO TO NEXT PAGE
M04-1856-5
6
5
7
1
4
4
3
2
9
8
M04-1856-6
TABLE 1
LVDT WIRE HARNESS
WHITE
BLUE
GREEN
ORANGE
CONNECTOR
PIN 1
PIN 2
PIN 3
PIN 4
2
1211
M04-1856-2
10
1.0 IN.
|
