|
| |
Back
NO. 5 TAIL ROTOR DRIVE SHAFT, DAMPER, AND ANTI-FLAIL SUPPORT REMOVAL/INSTALLATION – continued | Up
TM-1-1520-238-23-4 Helicopter Attack AH-64A Apache (NSN 1520-01-106-9519) (EIC: RHA) Manual | Next
NO. 5 TAIL ROTOR DRIVE SHAFT, DAMPER, AND ANTI-FLAIL SUPPORT REMOVAL/INSTALLATION – continued |
TM 1-1520-238-23
6-64
Change 4
6.11.
NO. 5 TAIL ROTOR DRIVE SHAFT, DAMPER, AND ANTI-FLAIL SUPPORT
REMOVAL/INSTALLATION – continued
6.11.7. Repair
a. Repair support (5) by replacing sleeve (26).
(1) Remove bends in lip ring (27).
(2) Remove and discard sleeve (26).
(3) Install new sleeve (26).
(4) Crimp lip of ring (27) between bends to se-
cure sleeve (26).
b. Repair support (5) by replacing doubler (28).
(1) Remove doubler (28) from support (5). Use
putty knife.
(2) Clean doubler (28) mating surface on support
(5). Use methyl ethyl ketone (item 124,
App F) and cloth (item 51, App F).
(3) Apply a thin, uniform coat of adhesive to dou-
bler (28) mating surface on support (5). Use
adhesive (item 3, App F).
(4) Install new doubler (28) on support (1) and
press firmly.
(5) Allow adhesive to cure for a minimum of 24
HOURS at room temperature.
GO TO NEXT PAGE
M04-0447-24
26
27
5
26
5
5
M04-0447-11
28
|
