|
| |
Back
NO. 5 TAIL ROTOR DRIVE SHAFT, DAMPER, AND ANTI-FLAIL SUPPORT REMOVAL/INSTALLATION | Up
TM-1-1520-238-23-4 Helicopter Attack AH-64A Apache (NSN 1520-01-106-9519) (EIC: RHA) Manual | Next
NO. 5 TAIL ROTOR DRIVE SHAFT, DAMPER, AND ANTI-FLAIL SUPPORT REMOVAL/INSTALLATION – continued |
TM 1-1520-238-23
6-58
6.11.
NO. 5 TAIL ROTOR DRIVE SHAFT, DAMPER, AND ANTI-FLAIL SUPPORT
REMOVAL/INSTALLATION – continued
CAUTION
·Exercise care and undertake protective
measures when handling or performing
any type of maintenance on tail rotor
drive shafts. All surface areas are critical.
Accidental dents or scratches caused by
improper handling may render part un-
serviceable.
·To prevent damage to tail rotor drive
shaft, ensure that work area is clean and
that part is placed on a soft and ade-
quately protected working surface.
6.11.3. Removal
a. Remove damper support (1) from deck (2).
(1) Remove seven screws (3) and washers (4)
from support (1).
(2) Slide support (1) off deck (2).
b. Remove anti-flail support (5) from deck (2).
(1) Remove seven screws (6) and washers (7)
from support (5).
(2) Slide support (5) off deck (2).
NOTE
Anti-flail support may contain more than
one forward or aft shim. If multiple shims
are found installed under anti-flail sup-
port, remove and discard all shims.
(3) Remove and discard forward shim(s) (8) and
aft shim(s) (9).
GO TO NEXT PAGE
M04-0447-1
NO. 5 DRIVE SHAFT
3
3
1
M04-0447-2
4
4
2
9
6
7
6
7
5
M04-0447-3
8
2
VIEW
ROTATED
|
