|
| |
Back
NO. 4 TAIL ROTOR DRIVE SHAFT, DAMPER, AND ANTI-FLAIL SUPPORT REMOVAL/INSTALLATION – continued | Up
TM-1-1520-238-23-4 Helicopter Attack AH-64A Apache (NSN 1520-01-106-9519) (EIC: RHA) Manual | Next
NO. 4 TAIL ROTOR DRIVE SHAFT, DAMPER, AND ANTI-FLAIL SUPPORT REMOVAL/INSTALLATION – continued |
TM 1-1520-238-23
6-45
6.8.
NO. 4 TAIL ROTOR DRIVE SHAFT, DAMPER, AND ANTI-FLAIL SUPPORT
REMOVAL/INSTALLATION – continued
(2) Apply an overlay patch if cracks in flanged
holes are greater than 1/2 flange width but
extend less than 0.25 INCH into web
(TM 1-1500-204-23).
6.8.8. Installation
a. Install support (7) on shaft (10).
(1) Slide support (7) on forward end of shaft (10)
with support bracket (31) facing forward.
b. Install support (1) on shaft (10).
(1) Slide support (1) on aft end of shaft (10) with
support bracket (27) facing forward.
c. Install shaft (10) with supports (1) and (7) on
deck (2).
(1) Slide and position shaft (10) with supports (1)
and (7) on deck (2).
(2) Support both ends of shaft (10).
GO TO NEXT PAGE
M04-441-19
10
31
7
10
1
27
M04-441-20
7
1
10
M04-441-21
2
|
