|
| |
Back
NO. 4 TAIL ROTOR DRIVE SHAFT, DAMPER, AND ANTI-FLAIL SUPPORT REMOVAL/INSTALLATION – continued | Up
TM-1-1520-238-23-4 Helicopter Attack AH-64A Apache (NSN 1520-01-106-9519) (EIC: RHA) Manual | Next
NO. 4 TAIL ROTOR DRIVE SHAFT, DAMPER, AND ANTI-FLAIL SUPPORT REMOVAL/INSTALLATION – continued |
TM 1-1520-238-23
Change 4
6-43
6.8.
NO. 4 TAIL ROTOR DRIVE SHAFT, DAMPER, AND ANTI-FLAIL SUPPORT
REMOVAL/INSTALLATION – continued
d. Repair support (1) by replacing nutplates (30)
on bracket (27).
(1) Remove four screws (28) and washers (29)
attaching bracket (27) to support (1).
(2) Remove bracket (27) from support (1).
(3) Replace nutplates (30) on bracket (27)
(TM 1-1500-204-23).
(4) Position bracket (27) on support (1) and hold.
(5) Install four screws (28) through washers (29),
support (1), and bracket (27).
(6) Apply corrosion preventive compound to four
screws (28). Use corrosion preventive
compound (item 62A, App F).
e. Repair support (7) by replacing bracket (31).
(1) Remove four screws (32), washers (33), and
angle bracket (34) from support (7) and
bracket (31).
(2) Remove and discard bracket (31) from sup-
port (7).
(3) Position new bracket (31) and angle bracket
(34) on support (7).
(4) Install four screws (32) through washers (33),
bracket (34), support (7), and bracket (31).
(5) Apply corrosion preventive compound to four
screws (32). Use corrosion preventive
compound (item 62A, App F).
GO TO NEXT PAGE
1
28
29
27
30
M04-441-16
M04-441-17
7
31
33
34
32
|
