|
| |
Back
HINGE BUTT REPLACEMENT – continued | Up
TM-1-1520-238-23-2 Helicopter Attack AH-64A Apache (NSN 1520-01-106-9519) (EIC: RHA) Manual | Next
WING BARREL NUT REPLACEMENT |
TM 1-1520-238-23
2-61
2.24.
HINGE BUTT REPLACEMENT – continued
NOTE
When hinge pin is being installed, pin
length must be 1/8 to 3/16 INCH shorter
than hinge. If pin is too long, remove ex-
cess.
d. Install new pin (1) in hinge (2).
(1) Aline hinge halves (2).
(2) Install
pin
(1)
in
hinge
(2)
(TM 1-1500-204-23).
(3) Pin (1) must be centered in hinge (2) approxi-
mately 1/16 INCH from end of hinge (2).
(4) Stake hinge (2) in four places.
(5) If hinge (2) has been previously staked, rotate
stakes 90 degrees.
e. Inspect (QA).
END OF TASK
M04-1506-7
2
1
2
M04-1506-8
APPROXIMATELY
1/16 IN
APPROXIMATELY
1/16 IN
2
1
2
M04-1506-9
2
2
STAKES
M04-1506-10
2
2
PREVIOUS STAKES
NE STATKES
|
