Figure 3. P/N 298171-1 Splined Output Adapter Holder

TB 1-1520-238-30-19

NOTE

Friction disk cavity may have a small amount of wetness due to static leak-

age and operation. Do not reject clutch for this condition.

7.6 Separate outlet housing (Figure 1, Detail A) and attached parts from inlet housing.

7.7 Install plastic cap (P/N VC-437-16) on the end of the clutch (12) output shaft.

7.8 Bag or cover input section of clutch (12) - store in a clean area on work bench with the APU side down.

CAUTION

Immediately wipe off clutch debris/grease film from the aft opening

and ID surface of the splined output adapter (19) before the aft protec-

tive plastic plug is installed. Ensure the roller bearing (20) is not con-

taminated when doing this.

7.9 Install plastic cap (P/N VC-812-16) into the inner diameter of the aft opening of the splined output

adapter (19) to protect roller bearing (20) from contamination.

7.10 Place splined output adapter holder (P/N 298171-1, Figure 3) in bench vice.

Figure 3. P/N 298171-1 Splined Output Adapter Holder

7.11 Place splined output adapter (19) of outlet housing assembly on splined output adapter holder. Using

punch (P/N 3210689-1, Figure 4), unstake nut (16). Apply direct pressure downward while unstaking nut to

avoid damaging threads.

Figure 4. P/N 3210689-1 Alignment Punch