Parts to be Inspected

TB 1-1520-238-20-62

7. Parts to be Inspected. N/A.

8. Inspection. Perform the deactivation procedure identified in paragraph 9. If deactivation is not elected, no

further action is required. However, proceed to paragraph 9., 6 for Main Rotor Blade procurement information.

9. Correction Procedures.

a. Deactivation. Perform deactivation procedure as follows:

(1) Part I - Locate, pull and tie wrap the Blade De-ice (1 amp) and the Blade De-ice Controller

(5 amp) circuit breakers in the Pilot's Overhead Aft CB Panel.

(2) Part II - Access the Blade De-ice Relay XK-6 by first removing the Electrical Power

Distribution Box Cover per paragraph 9.9 of TM 1 -1520-238-23. Next, gain access to the XK-1

terminal block per paragraph 9.10 (Electrical Power Distribution Box Relay Cover) of TM 1-

1520-238-23. Locate and remove the relay located at position 6 on the XK-1 terminal block

(Refer to TM 55-1520-238 23P, figure 394 for location, and refer to TM 1 -1520-238-23,

paragraph 9.139 for removal). Install Relay Cover and Electrical Power Distribution Box Cover

after a technical inspector has confirmed that the correct relay was removed. Note that per DA

Form 2408-13 the Blade De-ice System is non-functional. A functional check of the windshield

and pitot tube heating systems shall be performed in order to ensure proper operation.

b. Main Rotor Blade Requisitioning Information. Due to failures of some Main Rotor Blade Heater

Blanket(s), unique part numbers and NSNs have been assigned as determined by operable and

inoperable heater blankets. The following tables are provided as an aid in acquisition of appropriate

blades.

NOTE

For units that need only blades with de-ice capability, requisition using NSN

1615-01-332-0702, and use advice code 2B. You will be issued only the

blades listed in table 1.

For units that need only blades with inoperable heater blankets, use NSN

1615-01-330-5098, and use advice code 2B. You will be issued only the

blades listed in table 2.

Regardless of the NSN used for requisitioning, if advice code 2B is not used,

units will be issued blades from either table 1 or 2 as supply availability

allows.

Table 1. Blades with Operable Heater Blankets

NSN

PART NUMBER

1615-01-147-4873

7-311412000

1615-01-310-4978

7-311412000-3

1615-01-332-0702

7-311412000-5

Table 2. Blades with Inoperable Heater Blankets

NSN

PART NUMBER

1615-01-331-2483

7-311412000 A

1615-01-330-5098

7-311412000 3A