 |
|||
|
Page Title:
Diagnostic connector assembly (DCA) |
|
||
| ||||||||||
|
|  MIL-C-53057(ME)
d. STE/ICE for test in 4.6.2.35.1
e. DCA tester for use in 4.6.2. 35.1
f. Cold-wet gloves.
(1) Shell, NSN 8415-00-269-5700.
(2) Liner, NSN 8415-00-682-6575.
3.41 Diagnostic connector assembly (DCA) The crane shall
.
incorporate an easily accessible DCA far interface with the
Government's simplified test equipment/internal combustion Engine
(STE/ICE) in accordance with STE/ICE design Guide for Vehicle
Diagnostic Connector Assemblies Report No. CR-82-588-003 and MIL-T-
62314, appendix B. The diagnostic connector shall be in accordance
with TACOM drawing 12258941. As a minimum, the DCA shall be capable
of monitoring the functions defined in table II of Report No. CR-82-
588-003 and alternator/generator output voltage, alternator/generator
field voltage, alternator/generator negative cable voltage drop, fuel
solenoid voltage, starter voltage, starter current first peak and
average, starter circuit resistance, battery internal resistance
charge, fuel supply pressure and fuel filter restriction (Delta P).
When specified (see 6.2), additional test parameters to be monitored
in either the DCA or transducer kit (TK) mode shall be as specified
in the contract. Test points identified to monitor functions in the
TK mode shall be accessible without the removal of major assemblies
and installed attachments. A separate wiring harness shall be
provided for the DCA and shall include all wiring and necessary
hardware to perform required capabilities. A fuel shut off method
-
shall be provided for conducting compression unbalance checks. The
contractor shall also provide STE/ICE vehicle test cards in the
format identified in TACOM drawing 12258955 addressing both DCA and
TK measurements and shall incorporate the test cards into the crane
technical manuals.
4. QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection Unless otherwise specified in
.
the contract, the contractor is responsible for the performance of
all inspection requirements as specified herein. Except as otherwise
specified in the contract, the contractor may use his own or any
other facilities suitable for the performance of the inspection
requirements specified herein, unless disapproved by the Government.
The Government reserves the right to perform any of the inspections
set forth in the specification where such inspections are deemed
necessary to assure that supplies and services conform to prescribed
requirements.
4.1.1 Component and material inspection The contractor is
.
responsible for insuring that components and materials used are
manufactured, examined, and tested in accordance with the
requirements of referenced specifications and standards.
4.2 Classification of inspections The inspection requirements
.
specified herein are classified as follows:
a. First article (preproduction) inspection (see 4.3).
40
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals